This power supply is an upgraded version of apw3 and it has few technology advantages compared to our apw3.
Bitmain power supply fan.
95 105 v a c.
80 89 v a c.
This is because it is in high temperature protection mode.
This power cable works great.
Check if power supply s output has been short circuited or overloaded.
Then plug in the power supply to the outlet pigtail.
There are a total of 10 plugs coming from the power supply so there will be one extra unused plug.
Psu repeatedly stops for a few seconds then resumes.
2 x 12038 fan over voltage protection.
In stock new antminer s9 13 5t bitcoin miner asic btc bitmain mining machine with power supply.
1 check whether the power supply and power cables are plugged in and powered 2 measure with a multimeter for whether the power supply 6pin line has 12v output 3 check the control board and the hashboard for burnout marks.
Power off the psu for 10 minutes then resume.
I highly recommend using a higher gauge power cord with it especially if using it to power a s9 t9 a3 or d3 220 volts.
Power factor 0 95 full load leakage current 1 5 ma 220 v 50 hz protection low voltage input.
5 pairs of 6 pin pcie connectors 10 connectors noise level 43 db input voltage range.
Power off protection trip time 9 ms.
47 63 hz.
This would cause the power supply to the protection mode.
Nema 6 15p to c13 power cord 6ft 250 220v cable for bitmain antminer apw3 apw7 power supply digital ballast cord industrial use u l certified and csa approved 14awg 15a 4 7 out of 5 stars 23 15 99 15.
Replace the control board.
Check whether the fan is spinning or not.
Yes over load protection.
Replace the faulty power supply 3.
2 x 12038 fan.
View return policy 6 976 00.
Re plug the line 2.
View return policy.
In stock new antminer s9 13 5t bitcoin miner asic btc bitmain mining machine with power supply.
I have 16 miners of all types the bitmain psu s are great.
2 rear fans size.
Plug in the ethernet cable to the antminer.
Apw7 is a new power supply model released by bitmain especially for our antminers.
If gauge is too low it will not power the supply only the fan within.
Cannot scan the miner.